Shock Therapy BSD Tie Rod Kit For 2017-2019 Can-Am Maverick X3 RS 2 Seat 72

Shock Therapy BSD Tie Rod Kit For 2017-2019 Can-Am Maverick X3 RS 2 Seat 72
Shock Therapy BSD Tie Rod Kit For 2017-2019 Can-Am Maverick X3 RS 2 Seat 72
Shock Therapy BSD Tie Rod Kit For 2017-2019 Can-Am Maverick X3 RS 2 Seat 72
Shock Therapy BSD Tie Rod Kit For 2017-2019 Can-Am Maverick X3 RS 2 Seat 72
Shock Therapy BSD Tie Rod Kit For 2017-2019 Can-Am Maverick X3 RS 2 Seat 72

Shock Therapy BSD Tie Rod Kit For 2017-2019 Can-Am Maverick X3 RS 2 Seat 72
Through rigorous testing of our shop car, we found that the X3 RS had a lot of steering wheel feed back in the whoops especially if you run a larger tire and turning in the whoops. After cycling the front suspension we found over 4 inches of bump steer in the factory system. Bump steer is a change in toe setting (front of tires closer together than the rear of the tires) through the cycle of front suspension travel.

The best set up is as close to zero toe change as possible. If your front tires change toe setting they are essentially doing the same thing as you turning the steering wheel slightly on every bump you hit. Bump steer is one of the biggest contributors to steering wheel feedback, twitchy drive ability, excessive front end wear and worn out forearms from trying to keep the car straight. So in an effort to eliminate all of these things we developed our BSD (bump steer delete) tie rod kit for the X3 RS.

Our kit relocates the outer tie rod pivot point which changes the front end geometry and lowers the factory 4 inch bump steer measurement down to just 3/8 of an inch! With the bump steer removed the car is much easier to drive, steer and control. What used to be a two handed steering wheel grab to hold the car in whoops is now just a few fingers on one hand. Your front end parts will last longer. Your car will drive more predictably. Your forearms will have no arm pump. The whole driving experience will become easier.

Don't wait, install our BSD Tie Rod Kit today. Note: This kit is designed to fix the geometry of the factory arm configuration.

It is NOT designed for any aftermarket arm system. We value your business and we are not satisfied until you are. Rudy's Performance Parts ships products from multiple warehouses across the country in order to get your products to you the quickest way possible.

We are not able to send ANY race use products to the state of California. According to the EPA Clean Air Act, they are illegal for use on any Federal, State, or Local public highways and illegal use is punishable by the penalties enacted by the mentioned laws. Rudy's Performance Parts does not condone or promote illegal use of these products. All of our parts and accessories are returnable and refundable. The item in which you are returning MUST be unused, uninstalled, in the original condition, and in the original packaging.

If you are returning an item due to an error caused by Rudys Performance Parts or its business partners i. If you are sending an item back, we recommend using a service with tracking and signature confirmation. This product is NOT for sale or use in California. The item "Shock Therapy BSD Tie Rod Kit For 2017-2019 Can-Am Maverick X3 RS 2 Seat 72" is in sale since Tuesday, September 15, 2020. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Suspension & Steering\Lift Kits & Parts".

The seller is "rudys_performance_parts" and is located in Phoenix, Arizona. This item can be shipped to United States.


Shock Therapy BSD Tie Rod Kit For 2017-2019 Can-Am Maverick X3 RS 2 Seat 72